However, these observations were made from a very limited number of samples, and thus need further Tideglusib clinical trial testing with larger sample numbers. Nearly all clones and isolates from building materials could be identified to species level by their nucITS sequences. Most of the fungi detected had been isolated from building materials before [41, 51, 52]. In addition, we identified several species

that have not previously been reported as contaminants of building materials (e.g. Penicillium canescens, Thielavia hyalocarpa, Cryptococcus adeliensis). Moreover, clones and isolates without close sequence relatives in DNA databases were also found. This confirms that the present, largely cultivation-based

view of www.selleckchem.com/btk.html building-associated fungal diversity is incomplete and should be studied in detail using cultivation-independent methods. Advanced isolation techniques using minimal selectivity [53], as well as novel massively parallel sequencing applications, may offer feasible alternatives to further elucidate this unexplored biodiversity from large numbers of samples. Effect of moisture damage and remediation ARRY-438162 on fungal assemblages in dust We found higher molecular diversity and ERMI scores in dusts collected from damaged buildings than their matched references. In contrast, elevated total concentrations of fungal biomass, total cell counts of common indoor molds or culturable fungi were not seen. Visible water damage and mold growth on surfaces is often associated with elevated concentrations of fungi in dust [25], but low levels in dust are not uncommon when the growth is located inside the building envelope [26], as was the case in the present study. The increased diversities

in index buildings were associated with fungal classes that include building inhabiting decomposers (Agaricomycetes) and saprotrophic molds (Dothideomycetes and Eurotiomycetes); elevated ERMI scores suggested Cediranib (AZD2171) an increase in water-associated fungi in index buildings. Despite this, few of the fungi detected from the water-damaged building materials were actually found in the corresponding dust samples, even using the combination of qPCR (a sensitive technique) and clone library sequencing (a non-selective technique). This may indicate that the transfer of DNA containing cell material from the site of growth to the room space was not remarkable compared to other fungal sources. On the other hand, the low number of shared taxa between materials and dust may have been a consequence of undersampling of materials from contaminated building sites and/or the failure to construct clone libraries from individual material samples. We used 69 different qPCR assays to study the fungi in dust, but this selection covered less than one third of the 45 phylotypes found in materials.