67 ± 8.02 cm, and total body mass of 80.35 ± 18.52 kg served as participants in the study. OICR-9429 ic50 The

participants were not resistance-trained [not following a consistent resistance training program (i.e. thrice weekly) for at least one year prior to the study], but were recreationally-active. All participants were cleared for participation by passing a mandatory medical screening. Participants with contraindications to exercise as outlined by the American Cobimetinib College of Sports Medicine and/or who had consumed any nutritional supplements (excluding multi-vitamins) such creatine monohydrate or various androstenedione derivatives or pharmacologic agents such as anabolic steroids three months prior to the study were not allowed to participate. All eligible subjects signed a university-approved informed consent document. Additionally, all experimental procedures involved in this study conformed to the ethical considerations of the Helsinki Code. Testing sessions The study included baseline testing at day 0, followed by testing sessions at days 6, 27, and 48 in which blood and muscle samples were obtained and where body composition and muscle performance tests were performed. Strength assessment The leg press and bench press maximal strength tests (Nebula, Versailles,

OH) were performed by the participants to measure any changes in muscular strength during the course of the study. Four one repetition maximum (1-RM) strength tests were performed during the study at days 0, 6, 27, BIBF1120 and 48. Initially, an estimated 50% (1-RM) measured from the previous testing 1-RM test, was utilized to complete 5 to 10 repetitions. After a two minute rest Dimethyl sulfoxide period, a load of 70% of estimated (1-RM) was utilized to perform 3 to 5 repetitions. Weight was gradually

increased until a 1-RM was reached with each following lift, with a two-minute rest period in between each successful lift. Test-retest reliability of performing these strength assessments on subjects within our laboratory has demonstrated low mean coefficients of variation and high reliability for the bench press (1.9%, intraclass r = 0.94) and leg press (0.7%, intraclass r = 0.91), respectively. Anaerobic power test Anaerobic power was determined during each of the four testing sessions at days 0, 6, 27, and 48, and expressed relative to body mass. The determinations were made by performing a 30-second Wingate test on a computerized Lode cycle ergometer (Groningen, Netherlands). A warm-up of 30 rpm for 120 seconds was followed by maximal sprint for 30 seconds against a workload of 0.075 kg/kg of body weight. Correlation coefficients of test-retest reliability of performing these assessments of absolute peak power and mean power on participants within our laboratory has been found to be r = 0.692 and r = 0.950, respectively. Body composition assessment Total body mass (kg) was determined on a standard dual beam balance scale (Detecto Bridgeview, IL).